Process weaving

First, the raw material yarn is divided into a yarn head into a cylinder head, and the yarn pulling machine is pulled into the pan head.

Two. After entering the shuttleless machine, the rear frame is penetrated into the medium silk piece by hand.

Three, the master adjusts a fine steel mouth into a good pull - in cylinder with a fine steel mouth, rows up the floral chain and out the gear in the gear, and adjusts a series of complex processes, such as the width, density, pattern, thickness and so on.

It can be made, plain, twill, pit, hollow, edge, jump point, etc.

The width of the trademark ribbon is 2MM-200MM and the thickness is 0.15MM-1MM.

Packing and beating process

First, the surface must be smooth and not defective.

Two, each can not exceed 3 joints, the unit is 100 yards per unit and can also be hit according to the requirements of the guest, the interface must be connected with the adhesive tape without a pin seal.

Three, do not pollute products during the beating process, such as dirt and dirt.

Evaluation of shipments

First, check whether the ribbon is smooth and non polluted.

Two, check whether the width of the ribbon is qualified, with flat surface without bending, and whether the interface is linked by adhesive tape.

Three, check whether the number of ribbon is correct, do data registration and check shipment.